The products of Transmission Hard Parts manufacturers will gradually wear out during the braking process of the car, and should be regarded as spare parts. If the driver does not pay attention to the wear of Transmission Pulley in daily life, it will not only cause safety risks due to the reduction of braking effect, but also seriously endanger the safety of passengers, so be cautious. The following issues should be paid special attention to in the daily inspection and maintenance of Transmission Pulley:
① Under the driving standard, the products of Transmission Hard Parts manufacturers should be inspected twice every 6,000 kilometers. In the inspection, not only the residual thickness should be measured, but also the damage of the Transmission Hard Parts should be checked. Compare whether the damage level of the Transmission Pulley on both sides is the same, whether the return is free, etc. If any abnormality is found, it must be handled immediately.
② Transmission Pulley are generally composed of two parts: steel back and friction material. It is necessary not to wait until the friction material parts are worn out before replacing the Transmission Hard Parts. Some cars have a brake alarm function. If the damage limit is exceeded, the digital display will alarm and remind replacement. Products of Transmission Hard Parts manufacturers that have exceeded their use limits must be replaced. Even if they can still be used for a while, the braking effect will be reduced and driving safety will be endangered.
③ When replacing, you must replace qualified Transmission Pulley produced by reliable manufacturers. Only in this way can the braking effect between the Transmission Hard Parts and the brake disc be optimal and the damage is minimal.
④ When replacing an Transmission Hard Parts, you must use maintenance tools to push the brake cylinder back. Do not use other crowbars to press it back hard, which may easily cause the brake caliper guide screw to bend and cause the Transmission Hard Parts to get stuck.
⑤ After replacing the Transmission Hard Parts brand product, you only need to step on the brakes a few times to clear the gap between the Transmission Hard Parts and the brake disc, and the Transmission Hard Parts needs to run-in for 150 kilometers to achieve good braking effect.
② Transmission Pulley are generally composed of two parts: steel back and friction material. It is necessary not to wait until the friction material parts are worn out before replacing the Transmission Hard Parts. Some cars have a brake alarm function. If the damage limit is exceeded, the digital display will alarm and remind replacement. Products of Transmission Hard Parts manufacturers that have exceeded their use limits must be replaced. Even if they can still be used for a while, the braking effect will be reduced and driving safety will be endangered.
③ When replacing, you must replace qualified Transmission Pulley produced by reliable manufacturers. Only in this way can the braking effect between the Transmission Hard Parts and the brake disc be optimal and the damage is minimal.
④ When replacing an Transmission Hard Parts, you must use maintenance tools to push the brake cylinder back. Do not use other crowbars to press it back hard, which may easily cause the brake caliper guide screw to bend and cause the Transmission Hard Parts to get stuck.
⑤ After replacing the Transmission Hard Parts brand product, you only need to step on the brakes a few times to clear the gap between the Transmission Hard Parts and the brake disc, and the Transmission Hard Parts needs to run-in for 150 kilometers to achieve good braking effect.